Hello experts!
I managed to run vomp on my new raspberry. At present, for testing it, is connected as follows:
- via the HDMI output and a HDMI -> DVI cable to a TFT display
- via the Video output to an old flat screen TV with low resolution
- via the stereo jack to some cheap active loud speaker.
Using the Vompclient configuration menu I was able to show the TV image on the TFT display. However with my following two efforts I failed:
(a) I tried to switch the picture via the vomp configuration to the video output -> I was not able to see a picture on the TV (the display changed somehow for a moment - but no picture at the end)
(b) I tried to stick with the hdmi output but to redirect the audio to the loud speaker using the VOMP configuration menu -> now both video outputs turn black after starting the vompclient
Unfortunately, I could not recover from (b) as I cannot access the vompclient configuration menu anymore for changing it.
My questions are:
- Is there a way to reset the "vompclient configuration" to its initial state so I can start checking again?
- Did I anything stupid which is the obvious reason why I failed with (a) and (b)
Amendment: I attached the present vompclient logfile, maybe it is helpful? Sorry for the two copies, one of them is for better reading with a Windows editor - apart from that they are the same.
Best wishes
Markus
I managed to run vomp on my new raspberry. At present, for testing it, is connected as follows:
- via the HDMI output and a HDMI -> DVI cable to a TFT display
- via the Video output to an old flat screen TV with low resolution
- via the stereo jack to some cheap active loud speaker.
Using the Vompclient configuration menu I was able to show the TV image on the TFT display. However with my following two efforts I failed:
(a) I tried to switch the picture via the vomp configuration to the video output -> I was not able to see a picture on the TV (the display changed somehow for a moment - but no picture at the end)
(b) I tried to stick with the hdmi output but to redirect the audio to the loud speaker using the VOMP configuration menu -> now both video outputs turn black after starting the vompclient
Unfortunately, I could not recover from (b) as I cannot access the vompclient configuration menu anymore for changing it.
My questions are:
- Is there a way to reset the "vompclient configuration" to its initial state so I can start checking again?
- Did I anything stupid which is the obvious reason why I failed with (a) and (b)
Amendment: I attached the present vompclient logfile, maybe it is helpful? Sorry for the two copies, one of them is for better reading with a Windows editor - apart from that they are the same.
Best wishes
Markus