Hi,
after updating from 0.2.2 to 0.2.3 I discovered a new behavior when I acidently switch to a channel which isn't available at this time (encrypted, not sending at this time , and so on).
With Version 0.2.2 the MVP waited some seconds and gave the message "Channel not available" or something simliar. But with 0.2.3 The MVP didn't react on anything.
I have to power down the box to recover from this state.
Is there a way to change this ?
Thanks
Genius
Hi,
I've observed the same symptoms with my MVP. It seems that this is not only an isolated case.
Greetings,
Radiofreak
I don´t have tryed it with al older Version - but i also can confirm, this behavior.
Maybe it's a sideeffect of the new PreBuffering.
It didn't happen with the Version 0.2.2.
genius
It happens when VDR dont deliver any date (for example when my PW-CI dont´t work again...) then the only way is to Power off the MVP.
When i disconnect the Network from the MVP (or turn off the WLAN-Router) the Client Say´s "Connection lost" and with a Press to the OK Button everything is ok.
BTW: Works great over WLAN (54mbit)
same here
Yes, this is a side effect from the new prebuffering / av-sync code changes made in the last version. I know what it is and I've put in on the SF bugs page. Thanks for the reports.
Just like to say that with the NEW Update this Problem is gone - now i get "Channel not ..." - Good Work !